We recently had a sink installed that sits a few inches lower than the old one. To accommodate, I added an extension to the p trap to lower it in line with the new location of the garbage disposal drain. I also added an elbow to replace the old T because we went from a dual to single basin. The two white PVC sections in the picture are new.
The drain seemed to be working fine with just the sink running. I even tugged on all of the connections by hand to make sure they were tight. When I used the garbage disposal, the connection with the red arrow burst off and started spraying water everywhere. I have no idea what I did wrong. I reinstalled the fitting and it feels tight again, but I'm too nervous to use the sink until I understand what's going on. Am I missing something here? Is there a different part I should be using or is this setup ok? I'm kind of at a loss, so any input would be appreciated.
[link] [comments]
from DIY https://ift.tt/38Q7MUw
没有评论:
发表评论