I use my brass setup bars frequently at my router table, so here’s how I keep them within easy reach. I routed a dado slot for each bar into a scrap piece of 3/4″ plywood that’s large enough to fit the set with the bars spaced 1/2″ apart. The front-to-back measurement of each dado is a finger width less than the bar length, and the dadoes are about 1/16″ deeper than necessary so the bars are easy to insert and remove. When I screwed the completed tray to the bottom of the tabletop, I wedged a 1/4″ dowel at the back so the tray tilts backward slightly. This keeps the bars from vibrating out during routing or while I’m moving the table around the shop.
– Ray Brakke
Morrison, Colorado
The post Brass Setup Bar Storage appeared first on Woodworking | Blog | Videos | Plans | How To.
from Woodworking | Blog | Videos | Plans | How To https://ift.tt/2D2d45y
没有评论:
发表评论